Change the Current View

Change the Current View

You can change the current view of a model by clicking predefined areas on the ViewCube or dragging the ViewCube.

The ViewCube provides 26 defined areas you can click to change the current view of a model. The defined areas are categorized into three groups: corner, edge, and face. Of the 26 defined areas, six represent standard orthographic views of a model: top, bottom, front, back, left, and right. You set an orthographic view by clicking one of the faces on the ViewCube.
You access angled views of the scene with the other 20 defined areas. Clicking one of the corners of the ViewCube changes the current view of the model to a three-fourths view, based on a viewpoint defined by three sides of the model. Clicking one of the edges changes the view of the model to a three-fourths view based on two sides of the model.

Roll a Face View

When you view a model from one of the face views such as Front, two additional icons, called roll arrows, are displayed near the ViewCube. To roll or rotate the current view 90 degrees in the positive or negative directions around the center of the view, click one of the roll arrows.

Switch to an Adjacent Face

While viewing a model from one of the face views, you can use the ViewCube to switch to one of the adjacent face views without first changing the view of the model, in order to see the adjacent view. When the ViewCube is active and a face view is current, four triangles are displayed, one on each side of the ViewCube. To rotate the current view to display the face view indicated by one of the triangles, click the triangle.

Front View

You can define the Front view of a model. The Front view is used to define the direction of the face views on the ViewCube. Along with the Front view, the Up direction of a model is also used to define the direction of the face views on the ViewCube.

Procedures

To change the current view to a preset view:

1. Activate the ViewCube.
2. Click one of the faces, edges or corners on the ViewCube.

To view an adjacent face:

1. Activate the ViewCube.
   NoteMake sure a face view is current.
2. Click one of the triangles displayed near the edges of the ViewCube.

To roll a face view:

1. Activate the ViewCube.
   NoteMake sure a face view is current.
2. Click one of the roll arrows displayed above and to the right of the ViewCube. Click the left roll arrow to rotate the view 90 degrees in a counterclockwise direction or click the right roll arrow to rotate the view 90 degrees in a clockwise direction.

To change the view interactively:

• Click the ViewCube, hold down the button on your pointing device and drag to orbit the model. Drag in the direction that you want to orbit the model.

To define the Front view:

• Right-click on the ViewCube and click Set Current View as Front.

NoteYou first need to orient the view using a view tool so that you are looking at what you consider to be the Front of the model with its Top facing upward and then choose Set Current View as Front.

To restore the default Front view:

• Right-click the ViewCube and click Reset Front.